Hylec Controls and CSZ Industrial help maintenance teams at remote mine sites

Hylec Controls, CSZ Industrial’s agent in Australia and New Zealand, thinks a ruggedised and robust skid-mounted industrial freezer could solve the problem of fitting new bearings into existing pieces of equipment at remote mine sites.

The conventional way to fit new bearings into existing pieces of equipment is to heat the outer housing with a flame to allow the bearing to fit, Hylec said.

An alternative method has been to use liquid nitrogen to freeze and shrink the component prior to fitting. At remote mine sites, this can be expensive and inconvenient as the liquid nitrogen often must be shipped from capital cities which is costly and time consuming, according to Hylec.

“Another alternative method is to use a two-stage water-cooled industrial freezer which is capable of freezing the item to -70°C, or, with the use of liquid nitrogen, boost down to -180°C,” Hylec said.

“Pre-cooling the item in a freezer minimises the use of liquid nitrogen – and in most cases nitrogen boost is not required. These chambers are normally installed in a workshop and the part must be brought to the workshop for fitting, which is often not feasible.”

CSZ Industrial’s ruggedised industrial freezer, which is connected to an air-cooled water chiller, can all be skid-mounted on the back of a truck and taken to the site where the item needs to be fitted, according to Hylec. “The air-cooled water chiller eliminates the need of a suitable mineral-free water supply, which is often not available on site. This can operate up to ambience up to +55°C,” it said.

“If the chiller is used in a workshop environment and used continuously, it is possible to speed up the chilling process by filling the chamber with delaminate, a natural liquid that freezes at about -90°C,” Hylec said. “This allows the part to be cooled much faster than if air-cooled with the freezer. Other metallurgical applications with steel include age hardening, stress relieving, martensiting, and dimensional stabilisation.”